When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

The valve body and bonnet are made of castings and are connected by flange joints. The seat surface of the valve seat and the wedges conform to the API 600 standard. The seat ring is welded into the valve body.

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

For decades, globe valves have been considered the industry standard for control valves. They are designed with a stem that moves up and down inside the valve to control flow. They are usually used in hot and cold water coils, and larger models are usuall

Do not use the valve as a crowbar to open the flange, as this may cause damage to the flange area and/or damage to the O-ring seal.

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

The three-way ball valve is made of stainless steel and can withstand a working pressure of 1000 PSI. The available ports are L-Port or T-Port. The ball valve is connected at the threaded end: BSPP or NPT.

The working principle of the stop valve is the vertical movement of the valve disc away from the valve seat. So when the valve is closed, it will cause the space between the disc and the seat ring to close. This is why these valves are used to start, stop

Concentric design wafer butterfly valve, with no back structure, rubber welded valve body, replaceable elastic seat, streamlined disc, integrated stem

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane

Gate valves are used in a variety of industrial applications, including oil and gas, pharmaceuticals, manufacturing, automobiles, and ships.

The stop valve is a linear motion valve, which can be used to start and stop and adjust the fluid flow. The stop valve is mainly used for throttling service and automatic control.

Types of butterfly valves: lug type butterfly valve, U-shaped flange butterfly valve, double flange butterfly valve, fluorine-lined PTFE butterfly valve, double eccentric butterfly valve and triple eccentric butterfly valve

Gate valves and globe valves are the two most common types of valves in industrial applications. Both have made great contributions to any industrial service. They may look similar, but the functions of these valves are different.

A three-way ball valve is a three-way valve that allows fluid to flow to an alternative path to the hydraulic system. It allows fluid to enter and exit the valve through more than one port.