If the flow, volume and pressure can be adjusted frequently, the stop valve can be used as a control valve. The design of the shut-off valve makes it very suitable for flow regulation and start and stop flow.

Gate valves and globe valves are the two most common types of valves in industrial applications. Both have made great contributions to any industrial service. They may look similar, but the functions of these valves are different.

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

Cast iron gate valves are used in commercial and industrial applications. Its typical services include: hot and cold water, HVAC, steam, gas and other general utility services.

They are used as isolation valves in pipelines and should not be used as control or regulating valves. The operation of the gate valve is accomplished by turning the valve stem clockwise to close (CTC) or clockwise to open (CTO). When you turn the stem, t

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the

The valve seat of the gate valve is either provided integrally with the valve body or adopts a seat ring structure. The valve seat provided by the valve seat ring structure can be screwed into place or pressed into place and sealed and welded to the valve

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

The working principle of the stop valve is the vertical movement of the valve disc away from the valve seat. So when the valve is closed, it will cause the space between the disc and the seat ring to close. This is why these valves are used to start, stop

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o

The stop valve opens and closes the valve with the help of a plug-shaped disc, which is tightly fixed in the valve.

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

These shut-off valves must not be used for on/off service because it is impossible to achieve a tight seal. The disc in the valve can be completely removed from the flow path, or the flow path can be completely closed.

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.