The sealing ring adopts seatback type, mortise type or directly vulcanized on the valve body. The sealing surface of the valve seat flange adopts an O-ring to cooperate with the pipe flange cone, and the sealing effect is good. It is easy to disassemble a

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

The gate valve is an energy-saving valve option because the direction of movement or gate is perpendicular to the direction of medium flow. Therefore, less power is consumed when opening or closing the gate valve compared to the shut-off valve. Because of

The three-way ball valve is made of stainless steel and can withstand a working pressure of 1000 PSI. The available ports are L-Port or T-Port. The ball valve is connected at the threaded end: BSPP or NPT.

Good sealing performance improves the reliability of the system. The friction resistance is small, the opening and closing is forceful and flexible. It has a long service life and can be switched repeatedly. High pressure and high temperature resistance,

The manual gate valve is operated by a simple handwheel to raise the valve stem and gate. When closed, the gate rests on a seat ring, both of which are specially treated to provide a reliable closure.

The gate valve is a two-way sealed valve. The valve body-bonnet joint and packing chamber are sealed with non-asbestos gaskets and packing to ensure a long service life.

The valve seat is responsible for the movement of the valve gate. It can also help to further seal the flowing medium. For gate valves, there are two valve seats according to the type of gate. Take the wedge valve as an example, the valve seats on both si

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

The closing function of gate valves is very good. They provide laminar flow with minimal pressure loss.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

Concentric design wafer butterfly valve, with no back structure, rubber welded valve body, replaceable elastic seat, streamlined disc, integrated stem