The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The gate valve is externally threaded and yoke type full bore, with elastic wedge and rising stem.

In the 19th century, due to the increasing use of gate valves in industrial operations, their intensive development moved forward rapidly. Over time, the materials involved in manufacturing have been improved and modified to suit different applications.

Ball valves are widely used in petroleum and natural gas, chemical and petrochemical, food industry, water supply, water treatment, building construction, light industry, power generation, pharmaceuticals, biotechnology, laboratory equipment, marine and o

The valve is bidirectional and can be installed in any direction relative to the water flow. The valve will control the flow equally in either direction. In order to obtain the best valve control and stable performance, the inlet straight pipe section sho

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

High-performance stainless steel butterfly valves are one of the most widely used butterfly valve types in processed food-grade products. They are also used to treat corrosive fluids. Stainless steel butterfly valve adopts SS304, SS316 or SS316L body mate

In the shut-off valve, the flow of water is controlled by a movable mandrel, and the flow of water is restricted by lowering the mandrel to a fixed valve seat.

These shut-off valves must not be used for on/off service because it is impossible to achieve a tight seal. The disc in the valve can be completely removed from the flow path, or the flow path can be completely closed.

The gate valve is a two-way sealed valve. The valve body-bonnet joint and packing chamber are sealed with non-asbestos gaskets and packing to ensure a long service life.

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

Gate valves Gate valves are called rising valves or non-rising valves. Around the non-vertical stem gate valve, the stem is screwed into the gate around the lower end surface. Because the handwheel around the valve stem rotates, the gate will move the val

The pressure-sealed gate valve is designed in accordance with API 600, suitable for high temperature and high pressure working conditions, and is widely used in nuclear power plants and thermal power plants. Compared with bolted bonnet joint valves, they

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the