Ball valve is a form of right-angle rotary valve, which uses a hollow, perforated and rotating ball to control it. It is open when the hole of the ball is aligned with the hole of the ball, and it is closed when it is rotated 90 degrees by the valve handl

There are many types of gate valves, such as full bore gate valves, parallel disc gate valves, solid wedge gate valves, flexible wedge gate valves, split wedge gate valves, vertical stem gate valves, and non-vertical stem gate valves.

Floating ball valves are widely used in various industries and attract more end users to replace gate valves and globe valves in cryogenic applications.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

In a system with irregular changes in high temperature, the gate valve will leak due to the load in the valve end pipe.

Cast iron gate valves are used in commercial and industrial applications. Its typical services include: hot and cold water, HVAC, steam, gas and other general utility services.

The main difference between these two types is the way they are closed. The stop valve uses a plug (stem) that closes against the flow, while the ball valve has a gate (ball) that can close the entire flow. The stop valve is suitable for adjusting the flo

The gate valve is a two-way sealed valve. The valve body-bonnet joint and packing chamber are sealed with non-asbestos gaskets and packing to ensure a long service life.

The main difference between ball valves and globe valves is the way they close. A ball valve has a stem and a ball, which rotate horizontally and are usually called "rotary" valves. The globe valve has a stem and a plug, which stroke linearly, a

Wafer type is a common style of butterfly valve, which is cheaper than lug type. The wafer butterfly valve is installed between two flanges. The valve is held in place from flange to flange by using bolts or studs and nuts. Of course, this type of install

Gate valves are very reliable in shutting off the water supply. They are usually used as shut-off valves for the main water supply line and branch water supply lines, although ball valves are gradually becoming more and more popular in these applications.

The gate valve is composed of three main parts: the valve body, the valve cover and the valve trim. The body is generally connected with other equipment through flange, thread or welding connection. The engine cover containing the moving parts is usually

The valve is bidirectional and can be installed in any direction relative to the water flow. The valve will control the flow equally in either direction. In order to obtain the best valve control and stable performance, the inlet straight pipe section sho

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

The plug or disc is an important part of the valve. It is connected to the valve stem and can be used for throttling.