The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

Gate valves are widely used in all types of applications, suitable for above-ground and underground installations. Especially for underground installations, it is important to choose the correct type of valve to avoid high replacement costs.

The gate valve is a valve that completely restricts the flow of fluid and provides a full-diameter valve without changing the direction. The valve disc is appropriately called a gate here and is moved into the fluid at right angles by a threaded shaft wor

The gate valve has a closing/closing mechanism. There is an upward internal gate device that allows the medium to flow and closes the valve downward. A distinctive feature of the gate valve is its straight passage, which reduces pressure loss and is easy

Forged steel gate valves are available in three bonnet designs. The first design is a bolted bonnet with male and female joints and spiral wound gaskets, made of F304/graphite. Ring joint gaskets are also available on request. The second design is a welde

Gate valves and globe valves are the two most common types of valves in industrial applications. Both have made great contributions to any industrial service. They may look similar, but the functions of these valves are different.

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or

The assembly, start-up, and maintenance of gate valves require a lot of space.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

The operation of the gate valve is to perform a clockwise closing (CTC) or clockwise opening (CTO) rotary movement of the valve stem. When the valve stem is operated, the gate moves up or down on the threaded part of the valve stem.

The valve is made of stainless steel and the material is 304/316. They can be used to control the flow of water, oil and gas, including various corrosive and radioactive media.

This kind of gate valve is more flexible, because its gate can move up or down, there is no obstacle to the flow of fluid or gas, thus ensuring less friction.

The closing function of gate valves is very good. They provide laminar flow with minimal pressure loss.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces