Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

Gate valves are widely used in all types of applications, suitable for above-ground and underground installations. Especially for underground installations, it is important to choose the correct type of valve to avoid high replacement costs.

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

Do not use the valve as a crowbar to open the flange, as this may cause damage to the flange area and/or damage to the O-ring seal.

These shut-off valves have one or more ports, and their valve bodies are spherical around the port area.

The main difference between these two types is the way they are closed. The stop valve uses a plug (stem) that closes against the flow, while the ball valve has a gate (ball) that can close the entire flow. The stop valve is suitable for adjusting the flo

The sealing ring adopts seatback type, mortise type or directly vulcanized on the valve body. The sealing surface of the valve seat flange adopts an O-ring to cooperate with the pipe flange cone, and the sealing effect is good. It is easy to disassemble a

Compared with ball valves, gate valves require multiple turns to fully open. The valve is not suitable for throttling or control, because partial opening will cause damage to the gate and wear of the valve seat. In addition, some valve closures can cause

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

If the flow, volume and pressure can be adjusted frequently, the stop valve can be used as a control valve. The design of the shut-off valve makes it very suitable for flow regulation and start and stop flow.

The gate valve allows the user to control the flow pressure instead of simply closing or opening it. Compared with ball valves, gate valves provide users with more control over water flow and pressure, but they cannot let users choose to stop the water fl

Wafer type is a common style of butterfly valve, which is cheaper than lug type. The wafer butterfly valve is installed between two flanges. The valve is held in place from flange to flange by using bolts or studs and nuts. Of course, this type of install

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

Floating ball valves are widely used in various industries and attract more end users to replace gate valves and globe valves in cryogenic applications.

The gate valve is designed for fully open or fully closed service. They are installed in the pipeline as isolation valves and should not be used as control or regulating valves.