The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

Ball valve is a form of right-angle rotary valve, which uses a hollow, perforated and rotating ball to control it. It is open when the hole of the ball is aligned with the hole of the ball, and it is closed when it is rotated 90 degrees by the valve handl

The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use. These qualities make them an excellent choice for shut-off applications where they are generally more popular than ga

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

You should store the valve on the floor in a clean, dry indoor area. Protect the valve from extreme temperatures and humidity, as well as exposure to excessive dust, humidity, vibration, deformation, sunlight and ozone.

The assembly, start-up, and maintenance of gate valves require a lot of space.

Control valves are an essential part of any piping unit. The basic function of these valves is to manage the flow of medium through different piping areas of a system. Ball and plug valves are two types of control valves that have similar functions and ar

Our gate valves are cheap, but durable and reliable. We believe that our deep research and development and rich production experience are important reasons why we are trustworthy.

For non-vertical stem type valves, if the valve is opened, the stem will not move upward. The stem is screwed into the dish. When the handwheel on the valve stem rotates, the disc moves up or down along the valve stem on the thread, while the valve stem r

Resilient seat gate valves are used for purification and pumping of sewage, fire fighting systems, irrigation, industrial pipelines, etc. It has minimal head loss, 100% water tightness and full bore.

The three-way ball valve is made of stainless steel and can withstand a working pressure of 1000 PSI. The available ports are L-Port or T-Port. The ball valve is connected at the threaded end: BSPP or NPT.

The gate valve allows the user to control the flow pressure instead of simply closing or opening it. Compared with ball valves, gate valves provide users with more control over water flow and pressure, but they cannot let users choose to stop the water fl