Globe valves are considered the industry standard for control valves because they are good at regulating flow, while ball valves are more suitable for on/off control without pressure drop.

The main difference between these two types is the way they are closed. The stop valve uses a plug (stem) that closes against the flow, while the ball valve has a gate (ball) that can close the entire flow. The stop valve is suitable for adjusting the flo

They are used as isolation valves in pipelines and should not be used as control or regulating valves. The operation of the gate valve is accomplished by turning the valve stem clockwise to close (CTC) or clockwise to open (CTO). When you turn the stem, t

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

Forged steel gate valves are available in three bonnet designs. The first design is a bolted bonnet with male and female joints and spiral wound gaskets, made of F304/graphite. Ring joint gaskets are also available on request. The second design is a welde

The gate valve is a two-way sealed valve. The valve body-bonnet joint and packing chamber are sealed with non-asbestos gaskets and packing to ensure a long service life.

The gate valve is composed of three main parts: the valve body, the valve cover and the valve trim. The body is generally connected with other equipment through flange, thread or welding connection. The engine cover containing the moving parts is usually

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

Our company can also provide customized valve services according to your requirements. Feel free to contact us for more information or to request a complete product category.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the

The closing function of gate valves is very good. They provide laminar flow with minimal pressure loss.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

Generally, gate valves are used to completely close the fluid flow in the pipeline, or to provide the full flow in the pipeline when fully opened. Therefore, it can be used in a fully closed or fully open position.