The valve is bidirectional and can be installed in any direction relative to the water flow. The valve will control the flow equally in either direction. In order to obtain the best valve control and stable performance, the inlet straight pipe section sho

A stainless steel 3/4 ball valve is considered not only rugged and durable, but they also perform well after many cycles. In addition, the reliability of stainless steel mini ball valves is also worthy of attention, because they can be safely closed even

In the shut-off valve, the flow of water is controlled by a movable mandrel, and the flow of water is restricted by lowering the mandrel to a fixed valve seat.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

This is the connection from the actuator to the valve, which provides the driving force. The stem of the actuator control valve can be smooth, and the stem of the manual control valve can be threaded.

Our company can also provide customized valve services according to your requirements. Feel free to contact us for more information or to request a complete product category.

This kind of gate valve is more flexible, because its gate can move up or down, there is no obstacle to the flow of fluid or gas, thus ensuring less friction.

The gate valve is an energy-saving valve option because the direction of movement or gate is perpendicular to the direction of medium flow. Therefore, less power is consumed when opening or closing the gate valve compared to the shut-off valve. Because of

Types of butterfly valves: lug type butterfly valve, U-shaped flange butterfly valve, double flange butterfly valve, fluorine-lined PTFE butterfly valve, double eccentric butterfly valve and triple eccentric butterfly valve

The main difference between these two types is the way they are closed. The stop valve uses a plug (stem) that closes against the flow, while the ball valve has a gate (ball) that can close the entire flow. The stop valve is suitable for adjusting the flo

We produce cast iron wafer butterfly valves, with hand lever or worm gear Operator. Our Butterfly Valves are widely used in drinking water system, sewage system, fire-fighting system. Butterfly Valves can produce from size DN40 to DN2400.