The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

Electric actuator ball valves have full-diameter models, some are cavity-filled, and some are V-shaped ball valves. Designed for throttling or switching applications in a variety of industries, including pulp and paper, chemical, power, oil and gas, and m

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

Gate valves are widely used in all types of applications, suitable for above-ground and underground installations. Especially for underground installations, it is important to choose the correct type of valve to avoid high replacement costs.

The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

The operation of the gate valve is to perform a clockwise closing (CTC) or clockwise opening (CTO) rotary movement of the valve stem. When the valve stem is operated, the gate moves up or down on the threaded part of the valve stem.

Gate valves are used in a variety of industrial applications, including oil and gas, pharmaceuticals, manufacturing, automobiles, and ships.

For decades, globe valves have been considered the industry standard for control valves. They are designed with a stem that moves up and down inside the valve to control flow. They are usually used in hot and cold water coils, and larger models are usuall

The working principle of the stop valve is the vertical movement of the valve disc away from the valve seat. So when the valve is closed, it will cause the space between the disc and the seat ring to close. This is why these valves are used to start, stop

Its working principle is to lift or press a rectangular or circular gate connected by the valve stem to the fluid path by rotating the handle wheel clockwise and counterclockwise.

Gate valves and globe valves are the two most common types of valves in industrial applications. Both have made great contributions to any industrial service. They may look similar, but the functions of these valves are different.

The pressure-sealed gate valve is designed in accordance with API 600, suitable for high temperature and high pressure working conditions, and is widely used in nuclear power plants and thermal power plants. Compared with bolted bonnet joint valves, they

The stop valve opens and closes the valve with the help of a plug-shaped disc, which is tightly fixed in the valve.

Push-in joints do not require solder, glue, unions or tools. Corrosion resistant to extend service life, designed for drinking water distribution and circulating heating applications.