The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

They are used as isolation valves in pipelines and should not be used as control or regulating valves. The operation of the gate valve is accomplished by turning the valve stem clockwise to close (CTC) or clockwise to open (CTO). When you turn the stem, t

Ball valve is a form of right-angle rotary valve, which uses a hollow, perforated and rotating ball to control it. It is open when the hole of the ball is aligned with the hole of the ball, and it is closed when it is rotated 90 degrees by the valve handl

Simple structure, convenient operation, convenient installation, good sealing performance, long service life, high reliability, good interchangeability of parts, and cost saving.

The valve seat of the gate valve is either provided integrally with the valve body or adopts a seat ring structure. The valve seat provided by the valve seat ring structure can be screwed into place or pressed into place and sealed and welded to the valve

Gate valves are widely used in pipelines to transport media. Gate valves can be divided into wedge gate valves, flat gate valves, parallel double gate valves according to the form of valve seats. The product can have a longer service life. It can be insta

The pressure-sealed gate valve is designed in accordance with API 600, suitable for high temperature and high pressure working conditions, and is widely used in nuclear power plants and thermal power plants. Compared with bolted bonnet joint valves, they

Globe valves are considered the industry standard for control valves because they are good at regulating flow, while ball valves are more suitable for on/off control without pressure drop.

The main difference between ball valves and globe valves is the way they close. A ball valve has a stem and a ball, which rotate horizontally and are usually called "rotary" valves. The globe valve has a stem and a plug, which stroke linearly, a

The stop valve is a linear motion valve, which can be used to start and stop and adjust the fluid flow. The stop valve is mainly used for throttling service and automatic control.

The gate valve is externally threaded and yoke type full bore, with elastic wedge and rising stem.

The working principle of the stop valve is the vertical movement of the valve disc away from the valve seat. So when the valve is closed, it will cause the space between the disc and the seat ring to close. This is why these valves are used to start, stop

The valve is made of stainless steel and the material is 304/316. They can be used to control the flow of water, oil and gas, including various corrosive and radioactive media.

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang