The gate valve is designed for fully open or fully closed service. They are installed in the pipeline as isolation valves and should not be used as control or regulating valves.

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o

This kind of gate valve is more flexible, because its gate can move up or down, there is no obstacle to the flow of fluid or gas, thus ensuring less friction.

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The stop valve opens and closes the valve with the help of a plug-shaped disc, which is tightly fixed in the valve.

The plug or disc is an important part of the valve. It is connected to the valve stem and can be used for throttling.

The assembly, start-up, and maintenance of gate valves require a lot of space.

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

The valve cage is a part of the valve, which surrounds the valve plug and is located in the valve body. The valve cage is the main component that determines the fluid flow in the valve. As the stopper moves, more cage openings are exposed and the flow rat

When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

The manual gate valve is operated by a simple handwheel to raise the valve stem and gate. When closed, the gate rests on a seat ring, both of which are specially treated to provide a reliable closure.

The valve is bidirectional and can be installed in any direction relative to the water flow. The valve will control the flow equally in either direction. In order to obtain the best valve control and stable performance, the inlet straight pipe section sho

The valve seat of the gate valve is either provided integrally with the valve body or adopts a seat ring structure. The valve seat provided by the valve seat ring structure can be screwed into place or pressed into place and sealed and welded to the valve