The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

Because of their spherical shape, these valves are called shut-off valves, and an internal baffle separates the two halves of the valve body. The moving part of the shut-off valve is composed of the valve disc, the valve stem and the hand wheel.

The valve body and bonnet are made of castings and are connected by flange joints. The seat surface of the valve seat and the wedges conform to the API 600 standard. The seat ring is welded into the valve body.

Industrial applications such as power generation, mining and chemical industries use gate valve. What makes it useful is that the design limits flow barriers. In addition, there is minimal pressure drop. This kind of valve can also be used when the pressu

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or

The valve is bidirectional and can be installed in any direction relative to the water flow. The valve will control the flow equally in either direction. In order to obtain the best valve control and stable performance, the inlet straight pipe section sho

Push-in joints do not require solder, glue, unions or tools. Corrosion resistant to extend service life, designed for drinking water distribution and circulating heating applications.

Cast iron gate valves are used in commercial and industrial applications. Its typical services include: hot and cold water, HVAC, steam, gas and other general utility services.

A stainless steel 3/4 ball valve is considered not only rugged and durable, but they also perform well after many cycles. In addition, the reliability of stainless steel mini ball valves is also worthy of attention, because they can be safely closed even

Wafer type is a common style of butterfly valve, which is cheaper than lug type. The wafer butterfly valve is installed between two flanges. The valve is held in place from flange to flange by using bolts or studs and nuts. Of course, this type of install

This is the connection from the actuator to the valve, which provides the driving force. The stem of the actuator control valve can be smooth, and the stem of the manual control valve can be threaded.

The closing function of gate valves is very good. They provide laminar flow with minimal pressure loss.

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

You should store the valve on the floor in a clean, dry indoor area. Protect the valve from extreme temperatures and humidity, as well as exposure to excessive dust, humidity, vibration, deformation, sunlight and ozone.

Simple structure, convenient operation, convenient installation, good sealing performance, long service life, high reliability, good interchangeability of parts, and cost saving.