The gate valve is externally threaded and yoke type full bore, with elastic wedge and rising stem.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

The valve is made of stainless steel and the material is 304/316. They can be used to control the flow of water, oil and gas, including various corrosive and radioactive media.

The assembly, start-up, and maintenance of gate valves require a lot of space.

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o

The three-way ball valve is made of stainless steel and can withstand a working pressure of 1000 PSI. The available ports are L-Port or T-Port. The ball valve is connected at the threaded end: BSPP or NPT.

The valve body is made of 304 stainless steel, which is rust-proof and has a long service life. The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use.

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane

Resilient seat gate valves are used for purification and pumping of sewage, fire fighting systems, irrigation, industrial pipelines, etc. It has minimal head loss, 100% water tightness and full bore.

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

Cast iron gate valves are used in commercial and industrial applications. Its typical services include: hot and cold water, HVAC, steam, gas and other general utility services.

The pressure-sealed gate valve is designed in accordance with API 600, suitable for high temperature and high pressure working conditions, and is widely used in nuclear power plants and thermal power plants. Compared with bolted bonnet joint valves, they

Ball valves are widely used in petroleum and natural gas, chemical and petrochemical, food industry, water supply, water treatment, building construction, light industry, power generation, pharmaceuticals, biotechnology, laboratory equipment, marine and o