The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The closing function of gate valves is very good. They provide laminar flow with minimal pressure loss.

Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

Our gate valve is more effective and saves installation space. It is widely used in urban water supply, sewage treatment, construction industry, petroleum pipeline, chemical industry, food, pharmaceutical, textile, electric power, shipbuilding, metallurgy

The globe valve is also a member of the linear motion valve family. Its functions include stopping and starting media and regulating the flow of media. Due to its design, the shut-off valve can provide a tight seal with less chance of leakage.

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o

Gate valves are widely used in all types of applications, suitable for above-ground and underground installations. Especially for underground installations, it is important to choose the correct type of valve to avoid high replacement costs.

A three-way ball valve is a three-way valve that allows fluid to flow to an alternative path to the hydraulic system. It allows fluid to enter and exit the valve through more than one port.

The three-way ball valve is made of stainless steel and can withstand a working pressure of 1000 PSI. The available ports are L-Port or T-Port. The ball valve is connected at the threaded end: BSPP or NPT.

Its working principle is to lift or press a rectangular or circular gate connected by the valve stem to the fluid path by rotating the handle wheel clockwise and counterclockwise.

The stop valve opens and closes the valve with the help of a plug-shaped disc, which is tightly fixed in the valve.

For non-vertical stem type valves, if the valve is opened, the stem will not move upward. The stem is screwed into the dish. When the handwheel on the valve stem rotates, the disc moves up or down along the valve stem on the thread, while the valve stem r