Compared with ball valves, gate valves require multiple turns to fully open. The valve is not suitable for throttling or control, because partial opening will cause damage to the gate and wear of the valve seat. In addition, some valve closures can cause

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

For decades, globe valves have been considered the industry standard for control valves. They are designed with a stem that moves up and down inside the valve to control flow. They are usually used in hot and cold water coils, and larger models are usuall

The gate valve is composed of three main parts: the valve body, the valve cover and the valve trim. The body is generally connected with other equipment through flange, thread or welding connection. The engine cover containing the moving parts is usually

In a system with irregular changes in high temperature, the gate valve will leak due to the load in the valve end pipe.

The valve is made of stainless steel and the material is 304/316. They can be used to control the flow of water, oil and gas, including various corrosive and radioactive media.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

A stainless steel 3/4 ball valve is considered not only rugged and durable, but they also perform well after many cycles. In addition, the reliability of stainless steel mini ball valves is also worthy of attention, because they can be safely closed even

The stop valve is a linear motion valve, which can be used to start and stop and adjust the fluid flow. The stop valve is mainly used for throttling service and automatic control.

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The gate valve is an energy-saving valve option because the direction of movement or gate is perpendicular to the direction of medium flow. Therefore, less power is consumed when opening or closing the gate valve compared to the shut-off valve. Because of

Ball valves are widely used in petroleum and natural gas, chemical and petrochemical, food industry, water supply, water treatment, building construction, light industry, power generation, pharmaceuticals, biotechnology, laboratory equipment, marine and o

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or