The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

Gate valves can be divided into two main types: parallel and wedge. The parallel gate valve uses a flat gate between two parallel valve seats. The popular type is a knife gate valve with sharp edges on the bottom of the gate.

The sealing ring adopts seatback type, mortise type or directly vulcanized on the valve body. The sealing surface of the valve seat flange adopts an O-ring to cooperate with the pipe flange cone, and the sealing effect is good. It is easy to disassemble a

Our company can also provide customized valve services according to your requirements. Feel free to contact us for more information or to request a complete product category.

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use. These qualities make them an excellent choice for shut-off applications where they are generally more popular than ga

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or

The manual gate valve is operated by a simple handwheel to raise the valve stem and gate. When closed, the gate rests on a seat ring, both of which are specially treated to provide a reliable closure.

The gate valve is composed of three main parts: the valve body, the valve cover and the valve trim. The body is generally connected with other equipment through flange, thread or welding connection. The engine cover containing the moving parts is usually

In a system with irregular changes in high temperature, the gate valve will leak due to the load in the valve end pipe.

The main difference between ball valves and globe valves is the way they close. A ball valve has a stem and a ball, which rotate horizontally and are usually called "rotary" valves. The globe valve has a stem and a plug, which stroke linearly, a

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

Ball valves are widely used in petroleum and natural gas, chemical and petrochemical, food industry, water supply, water treatment, building construction, light industry, power generation, pharmaceuticals, biotechnology, laboratory equipment, marine and o

Cast iron gate valves are used in commercial and industrial applications. Its typical services include: hot and cold water, HVAC, steam, gas and other general utility services.