The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

The gate valve is externally threaded and yoke type full bore, with elastic wedge and rising stem.

The globe valve is also a member of the linear motion valve family. Its functions include stopping and starting media and regulating the flow of media. Due to its design, the shut-off valve can provide a tight seal with less chance of leakage.

You should store the valve on the floor in a clean, dry indoor area. Protect the valve from extreme temperatures and humidity, as well as exposure to excessive dust, humidity, vibration, deformation, sunlight and ozone.

The main difference between ball valves and globe valves is the way they close. A ball valve has a stem and a ball, which rotate horizontally and are usually called "rotary" valves. The globe valve has a stem and a plug, which stroke linearly, a

For decades, globe valves have been considered the industry standard for control valves. They are designed with a stem that moves up and down inside the valve to control flow. They are usually used in hot and cold water coils, and larger models are usuall

Ball valve is a form of right-angle rotary valve, which uses a hollow, perforated and rotating ball to control it. It is open when the hole of the ball is aligned with the hole of the ball, and it is closed when it is rotated 90 degrees by the valve handl

When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

Its working principle is to lift or press a rectangular or circular gate connected by the valve stem to the fluid path by rotating the handle wheel clockwise and counterclockwise.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

For the product category of gate valve, we are a professional manufacturer from China, gate valve, flange gate valve supplier/factory, wholesale elastic sealing gate valve research and development and manufacturing of high-quality products, we have perfec

The valve is bidirectional and can be installed in any direction relative to the water flow. The valve will control the flow equally in either direction. In order to obtain the best valve control and stable performance, the inlet straight pipe section sho