Ball valves are valued for their long service life and excellent performance even after many years of use. Inside the ball valve, the ball is usually drilled from one end to the other, and is usually made of brass, chrome brass, or stainless steel. A leve

Gate valves are very reliable in shutting off the water supply. They are usually used as shut-off valves for the main water supply line and branch water supply lines, although ball valves are gradually becoming more and more popular in these applications.

Its working principle is to lift or press a rectangular or circular gate connected by the valve stem to the fluid path by rotating the handle wheel clockwise and counterclockwise.

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

Compared with ball valves, gate valves require multiple turns to fully open. The valve is not suitable for throttling or control, because partial opening will cause damage to the gate and wear of the valve seat. In addition, some valve closures can cause

These shut-off valves must not be used for on/off service because it is impossible to achieve a tight seal. The disc in the valve can be completely removed from the flow path, or the flow path can be completely closed.

The sealing ring adopts seatback type, mortise type or directly vulcanized on the valve body. The sealing surface of the valve seat flange adopts an O-ring to cooperate with the pipe flange cone, and the sealing effect is good. It is easy to disassemble a

Gate valves are used in a variety of industrial applications, including oil and gas, pharmaceuticals, manufacturing, automobiles, and ships.

Cast iron gate valves are used in commercial and industrial applications. Its typical services include: hot and cold water, HVAC, steam, gas and other general utility services.

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

Generally, gate valves are used to completely close the fluid flow in the pipeline, or to provide the full flow in the pipeline when fully opened. Therefore, it can be used in a fully closed or fully open position.

The gate valve can provide different discs or wedges. The range of the gate valve is usually determined by the type of wedge used.

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

The three-way ball valve is made of stainless steel and can withstand a working pressure of 1000 PSI. The available ports are L-Port or T-Port. The ball valve is connected at the threaded end: BSPP or NPT.