The gate valve has a closing/closing mechanism. There is an upward internal gate device that allows the medium to flow and closes the valve downward. A distinctive feature of the gate valve is its straight passage, which reduces pressure loss and is easy

Generally, gate valves are used to completely close the fluid flow in the pipeline, or to provide the full flow in the pipeline when fully opened. Therefore, it can be used in a fully closed or fully open position.

The valve body is made of 304 stainless steel, which is rust-proof and has a long service life. The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use.

The valve seat of the gate valve is either provided integrally with the valve body or adopts a seat ring structure. The valve seat provided by the valve seat ring structure can be screwed into place or pressed into place and sealed and welded to the valve

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

The gate valve can provide different discs or wedges. The range of the gate valve is usually determined by the type of wedge used.

The gate valve is composed of three main parts: the valve body, the valve cover and the valve trim. The body is generally connected with other equipment through flange, thread or welding connection. The engine cover containing the moving parts is usually

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o

The manual gate valve is operated by a simple handwheel to raise the valve stem and gate. When closed, the gate rests on a seat ring, both of which are specially treated to provide a reliable closure.

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

The assembly, start-up, and maintenance of gate valves require a lot of space.

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane

Compared with ball valves, gate valves require multiple turns to fully open. The valve is not suitable for throttling or control, because partial opening will cause damage to the gate and wear of the valve seat. In addition, some valve closures can cause