The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

The gate valve is a valve that completely restricts the flow of fluid and provides a full-diameter valve without changing the direction. The valve disc is appropriately called a gate here and is moved into the fluid at right angles by a threaded shaft wor

The valve is made of stainless steel and the material is 304/316. They can be used to control the flow of water, oil and gas, including various corrosive and radioactive media.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

You should store the valve on the floor in a clean, dry indoor area. Protect the valve from extreme temperatures and humidity, as well as exposure to excessive dust, humidity, vibration, deformation, sunlight and ozone.

Ball valves are widely used in petroleum and natural gas, chemical and petrochemical, food industry, water supply, water treatment, building construction, light industry, power generation, pharmaceuticals, biotechnology, laboratory equipment, marine and o

Gate valves are very reliable in shutting off the water supply. They are usually used as shut-off valves for the main water supply line and branch water supply lines, although ball valves are gradually becoming more and more popular in these applications.

A stainless steel 3/4 ball valve is considered not only rugged and durable, but they also perform well after many cycles. In addition, the reliability of stainless steel mini ball valves is also worthy of attention, because they can be safely closed even

Gate valves Gate valves are called rising valves or non-rising valves. Around the non-vertical stem gate valve, the stem is screwed into the gate around the lower end surface. Because the handwheel around the valve stem rotates, the gate will move the val

Industrial applications such as power generation, mining and chemical industries use gate valve. What makes it useful is that the design limits flow barriers. In addition, there is minimal pressure drop. This kind of valve can also be used when the pressu

The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o