The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

The closing function of gate valves is very good. They provide laminar flow with minimal pressure loss.

The gate valve is designed for fully open or fully closed service. They are installed in the pipeline as isolation valves and should not be used as control or regulating valves.

Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

Ball valve is a form of right-angle rotary valve, which uses a hollow, perforated and rotating ball to control it. It is open when the hole of the ball is aligned with the hole of the ball, and it is closed when it is rotated 90 degrees by the valve handl

Concentric design wafer butterfly valve, with no back structure, rubber welded valve body, replaceable elastic seat, streamlined disc, integrated stem

We are the world\'s most popular supplier of gate valves in China because we provide high-quality service and high-quality gate valves. Due to the top quality of our gate valve, it is suitable for a wide range of industrial and commercial applications. We

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o

The manual gate valve is operated by a simple handwheel to raise the valve stem and gate. When closed, the gate rests on a seat ring, both of which are specially treated to provide a reliable closure.

The gate valve can provide different discs or wedges. The range of the gate valve is usually determined by the type of wedge used.

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

The stop valve opens and closes the valve with the help of a plug-shaped disc, which is tightly fixed in the valve.

Do not use the valve as a crowbar to open the flange, as this may cause damage to the flange area and/or damage to the O-ring seal.