The plug or disc is an important part of the valve. It is connected to the valve stem and can be used for throttling.

For non-vertical stem type valves, if the valve is opened, the stem will not move upward. The stem is screwed into the dish. When the handwheel on the valve stem rotates, the disc moves up or down along the valve stem on the thread, while the valve stem r

The valve body and bonnet are made of castings and are connected by flange joints. The seat surface of the valve seat and the wedges conform to the API 600 standard. The seat ring is welded into the valve body.

The operation of the gate valve is to perform a clockwise closing (CTC) or clockwise opening (CTO) rotary movement of the valve stem. When the valve stem is operated, the gate moves up or down on the threaded part of the valve stem.

When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The pressure-sealed gate valve is designed in accordance with API 600, suitable for high temperature and high pressure working conditions, and is widely used in nuclear power plants and thermal power plants. Compared with bolted bonnet joint valves, they

Electric actuator ball valves have full-diameter models, some are cavity-filled, and some are V-shaped ball valves. Designed for throttling or switching applications in a variety of industries, including pulp and paper, chemical, power, oil and gas, and m

Push-in joints do not require solder, glue, unions or tools. Corrosion resistant to extend service life, designed for drinking water distribution and circulating heating applications.

Control valves are an essential part of any piping unit. The basic function of these valves is to manage the flow of medium through different piping areas of a system. Ball and plug valves are two types of control valves that have similar functions and ar

Wafer type is a common style of butterfly valve, which is cheaper than lug type. The wafer butterfly valve is installed between two flanges. The valve is held in place from flange to flange by using bolts or studs and nuts. Of course, this type of install

The main difference between ball valves and globe valves is the way they close. A ball valve has a stem and a ball, which rotate horizontally and are usually called "rotary" valves. The globe valve has a stem and a plug, which stroke linearly, a

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane

The valve body is made of 304 stainless steel, which is rust-proof and has a long service life. The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use.

A three-way ball valve is a three-way valve that allows fluid to flow to an alternative path to the hydraulic system. It allows fluid to enter and exit the valve through more than one port.