The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

Push-in joints do not require solder, glue, unions or tools. Corrosion resistant to extend service life, designed for drinking water distribution and circulating heating applications.

When the handle wheel is turned clockwise, steam and steam move down through the fluid flow, and the gate is squeezed between the two valve seats, so that no fluid leakage occurs when the valve is completely closed.

We test every valve during the production process, and carry out quality control in all processes such as forging, processing, and assembly to ensure quality.

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

The easy operation, maintenance and versatility of the ball valve make it widely used in industry. This high-quality ball valve will be an excellent choice for shut-off and control applications.

The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use. These qualities make them an excellent choice for shut-off applications where they are generally more popular than ga

The valve seat is responsible for the movement of the valve gate. It can also help to further seal the flowing medium. For gate valves, there are two valve seats according to the type of gate. Take the wedge valve as an example, the valve seats on both si

Floating ball valves are widely used in various industries and attract more end users to replace gate valves and globe valves in cryogenic applications.

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

If the flow, volume and pressure can be adjusted frequently, the stop valve can be used as a control valve. The design of the shut-off valve makes it very suitable for flow regulation and start and stop flow.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

The valve body and bonnet are made of castings and are connected by flange joints. The seat surface of the valve seat and the wedges conform to the API 600 standard. The seat ring is welded into the valve body.

The gate valve is externally threaded and yoke type full bore, with elastic wedge and rising stem.

Wafer type is a common style of butterfly valve, which is cheaper than lug type. The wafer butterfly valve is installed between two flanges. The valve is held in place from flange to flange by using bolts or studs and nuts. Of course, this type of install