Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

The valve body is made of 304 stainless steel, which is rust-proof and has a long service life. The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use.

The valve is bidirectional and can be installed in any direction relative to the water flow. The valve will control the flow equally in either direction. In order to obtain the best valve control and stable performance, the inlet straight pipe section sho

The sealing ring adopts seatback type, mortise type or directly vulcanized on the valve body. The sealing surface of the valve seat flange adopts an O-ring to cooperate with the pipe flange cone, and the sealing effect is good. It is easy to disassemble a

Gate valves serve to cut the medium flow in the piping system, widely used in the field of potable water, water supply and drainage, sewage disposal, irrigation, air conditioning, fire protection as well as chemical and energy industry.

The three-way ball valve is made of stainless steel and can withstand a working pressure of 1000 PSI. The available ports are L-Port or T-Port. The ball valve is connected at the threaded end: BSPP or NPT.

The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

Cast iron gate valves are used in commercial and industrial applications. Its typical services include: hot and cold water, HVAC, steam, gas and other general utility services.

Ball valves are valued for their long service life and excellent performance even after many years of use. Inside the ball valve, the ball is usually drilled from one end to the other, and is usually made of brass, chrome brass, or stainless steel. A leve

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g