Forged steel gate valves are available in three bonnet designs. The first design is a bolted bonnet with male and female joints and spiral wound gaskets, made of F304/graphite. Ring joint gaskets are also available on request. The second design is a welde

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

Because of their spherical shape, these valves are called shut-off valves, and an internal baffle separates the two halves of the valve body. The moving part of the shut-off valve is composed of the valve disc, the valve stem and the hand wheel.

The manual gate valve is operated by a simple handwheel to raise the valve stem and gate. When closed, the gate rests on a seat ring, both of which are specially treated to provide a reliable closure.

The gate valve is externally threaded and yoke type full bore, with elastic wedge and rising stem.

The most common causes of gate valve failure are wear and corrosion. Over time, gate valves tend to wear out. Corrosion can cause the disc to get stuck in the open or closed position. When the handle is stressed, the valve stem leading from the handle to

Gate valves Gate valves are called rising valves or non-rising valves. Around the non-vertical stem gate valve, the stem is screwed into the gate around the lower end surface. Because the handwheel around the valve stem rotates, the gate will move the val

The sealing ring adopts seatback type, mortise type or directly vulcanized on the valve body. The sealing surface of the valve seat flange adopts an O-ring to cooperate with the pipe flange cone, and the sealing effect is good. It is easy to disassemble a

Control valves are an essential part of any piping unit. The basic function of these valves is to manage the flow of medium through different piping areas of a system. Ball and plug valves are two types of control valves that have similar functions and ar

These shut-off valves have one or more ports, and their valve bodies are spherical around the port area.

The pressure-sealed gate valve is designed in accordance with API 600, suitable for high temperature and high pressure working conditions, and is widely used in nuclear power plants and thermal power plants. Compared with bolted bonnet joint valves, they

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

The stop valve is a linear motion valve, which can be used to start and stop and adjust the fluid flow. The stop valve is mainly used for throttling service and automatic control.

Gate valves can be divided into two main types: parallel and wedge. The parallel gate valve uses a flat gate between two parallel valve seats. The popular type is a knife gate valve with sharp edges on the bottom of the gate.