The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

For non-vertical stem type valves, if the valve is opened, the stem will not move upward. The stem is screwed into the dish. When the handwheel on the valve stem rotates, the disc moves up or down along the valve stem on the thread, while the valve stem r

The gate valve can provide different discs or wedges. The range of the gate valve is usually determined by the type of wedge used.

The operation of the gate valve is to perform a clockwise closing (CTC) or clockwise opening (CTO) rotary movement of the valve stem. When the valve stem is operated, the gate moves up or down on the threaded part of the valve stem.

Good sealing performance improves the reliability of the system. The friction resistance is small, the opening and closing is forceful and flexible. It has a long service life and can be switched repeatedly. High pressure and high temperature resistance,

The gate valve is the most common valve in the water supply system. It represents a linear motion isolation valve with the function of stopping or allowing flow. The gate valve is named after the closing element slides into the flow stream to provide clos

Ball valves are widely used in petroleum and natural gas, chemical and petrochemical, food industry, water supply, water treatment, building construction, light industry, power generation, pharmaceuticals, biotechnology, laboratory equipment, marine and o

The plug or disc is an important part of the valve. It is connected to the valve stem and can be used for throttling.

For decades, globe valves have been considered the industry standard for control valves. They are designed with a stem that moves up and down inside the valve to control flow. They are usually used in hot and cold water coils, and larger models are usuall

Simple structure, convenient operation, convenient installation, good sealing performance, long service life, high reliability, good interchangeability of parts, and cost saving.

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or

The gate valve is a two-way sealed valve. The valve body-bonnet joint and packing chamber are sealed with non-asbestos gaskets and packing to ensure a long service life.

We are the world\'s most popular supplier of gate valves in China because we provide high-quality service and high-quality gate valves. Due to the top quality of our gate valve, it is suitable for a wide range of industrial and commercial applications. We

A three-way ball valve is a three-way valve that allows fluid to flow to an alternative path to the hydraulic system. It allows fluid to enter and exit the valve through more than one port.

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the