Ball valve is a form of right-angle rotary valve, which uses a hollow, perforated and rotating ball to control it. It is open when the hole of the ball is aligned with the hole of the ball, and it is closed when it is rotated 90 degrees by the valve handl

The valve seat of the gate valve is parallel to the flow direction of the medium, so there is less erosion of the valve seat when the valve is opened. This also makes the globe valve a good throttle valve. The disadvantage is that due to its design, there

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

You should store the valve on the floor in a clean, dry indoor area. Protect the valve from extreme temperatures and humidity, as well as exposure to excessive dust, humidity, vibration, deformation, sunlight and ozone.

Gate valves are very reliable in shutting off the water supply. They are usually used as shut-off valves for the main water supply line and branch water supply lines, although ball valves are gradually becoming more and more popular in these applications.

Generally, gate valves are used to completely close the fluid flow in the pipeline, or to provide the full flow in the pipeline when fully opened. Therefore, it can be used in a fully closed or fully open position.

Do not use the valve as a crowbar to open the flange, as this may cause damage to the flange area and/or damage to the O-ring seal.

We are the world\'s most popular supplier of gate valves in China because we provide high-quality service and high-quality gate valves. Due to the top quality of our gate valve, it is suitable for a wide range of industrial and commercial applications. We

For non-vertical stem type valves, if the valve is opened, the stem will not move upward. The stem is screwed into the dish. When the handwheel on the valve stem rotates, the disc moves up or down along the valve stem on the thread, while the valve stem r

Ball valves are valued for their long service life and excellent performance even after many years of use. Inside the ball valve, the ball is usually drilled from one end to the other, and is usually made of brass, chrome brass, or stainless steel. A leve

The assembly, start-up, and maintenance of gate valves require a lot of space.

Gate valves and globe valves are the two most common types of valves in industrial applications. Both have made great contributions to any industrial service. They may look similar, but the functions of these valves are different.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

The valve body and bonnet are made of castings and are connected by flange joints. The seat surface of the valve seat and the wedges conform to the API 600 standard. The seat ring is welded into the valve body.

Gate valves can be divided into two main types: parallel and wedge. The parallel gate valve uses a flat gate between two parallel valve seats. The popular type is a knife gate valve with sharp edges on the bottom of the gate.