In a system with irregular changes in high temperature, the gate valve will leak due to the load in the valve end pipe.

The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use. These qualities make them an excellent choice for shut-off applications where they are generally more popular than ga

The gate valve cannot be opened and closed quickly. To fully open or close the wheel or gearbox actuator, the shaft should be rotated to the number of fully open revolutions. The number of full-open revolutions is equal to the pitch.

The valve body is made of 304 stainless steel, which is rust-proof and has a long service life. The ball valve is durable, performs well after many cycles, and is reliable, and can be safely closed even after long periods of non-use.

This kind of gate valve is more flexible, because its gate can move up or down, there is no obstacle to the flow of fluid or gas, thus ensuring less friction.

Gate valves serve to cut the medium flow in the piping system, widely used in the field of potable water, water supply and drainage, sewage disposal, irrigation, air conditioning, fire protection as well as chemical and energy industry.

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

Ball valves are valued for their long service life and excellent performance even after many years of use. Inside the ball valve, the ball is usually drilled from one end to the other, and is usually made of brass, chrome brass, or stainless steel. A leve

Good sealing performance improves the reliability of the system. The friction resistance is small, the opening and closing is forceful and flexible. It has a long service life and can be switched repeatedly. High pressure and high temperature resistance,

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

In the shut-off valve, the flow of water is controlled by a movable mandrel, and the flow of water is restricted by lowering the mandrel to a fixed valve seat.

Floating ball valves are widely used in various industries and attract more end users to replace gate valves and globe valves in cryogenic applications.

The three-piece ball valve uses the same dynamic multi-ring gland system as the needle valve to provide higher strength and integrity. When combined with the blowout prevention rear seat valve stem, it can ensure that it can withstand all operating proces

The operation of the gate valve is to perform a clockwise closing (CTC) or clockwise opening (CTO) rotary movement of the valve stem. When the valve stem is operated, the gate moves up or down on the threaded part of the valve stem.

Gate valves can be divided into two main types: parallel and wedge. The parallel gate valve uses a flat gate between two parallel valve seats. The popular type is a knife gate valve with sharp edges on the bottom of the gate.