Wafer type is a common style of butterfly valve, which is cheaper than lug type. The wafer butterfly valve is installed between two flanges. The valve is held in place from flange to flange by using bolts or studs and nuts. Of course, this type of install

Industrial applications such as power generation, mining and chemical industries use gate valve. What makes it useful is that the design limits flow barriers. In addition, there is minimal pressure drop. This kind of valve can also be used when the pressu

If the flow, volume and pressure can be adjusted frequently, the stop valve can be used as a control valve. The design of the shut-off valve makes it very suitable for flow regulation and start and stop flow.

They are used as isolation valves in pipelines and should not be used as control or regulating valves. The operation of the gate valve is accomplished by turning the valve stem clockwise to close (CTC) or clockwise to open (CTO). When you turn the stem, t

Globe valves are considered the industry standard for control valves because they are good at regulating flow, while ball valves are more suitable for on/off control without pressure drop.

We produce cast iron wafer butterfly valves, with hand lever or worm gear Operator. Our Butterfly Valves are widely used in drinking water system, sewage system, fire-fighting system. Butterfly Valves can produce from size DN40 to DN2400.

Ball valves are more effective in forming tight seals and have higher reliability and life than gate valves, but they are more expensive. They are often used to shut down and control applications. Because the ball valve can be opened and closed instantane

Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

Ball valves are widely used in petroleum and natural gas, chemical and petrochemical, food industry, water supply, water treatment, building construction, light industry, power generation, pharmaceuticals, biotechnology, laboratory equipment, marine and o

Simple structure, convenient operation, convenient installation, good sealing performance, long service life, high reliability, good interchangeability of parts, and cost saving.

The stop valve is a linear motion valve, which can be used to start and stop and adjust the fluid flow. The stop valve is mainly used for throttling service and automatic control.

The gate valve can provide different discs or wedges. The range of the gate valve is usually determined by the type of wedge used.

The valve body and bonnet are made of castings and are connected by flange joints. The seat surface of the valve seat and the wedges conform to the API 600 standard. The seat ring is welded into the valve body.

Gate valves can be divided into two main types: parallel and wedge. The parallel gate valve uses a flat gate between two parallel valve seats. The popular type is a knife gate valve with sharp edges on the bottom of the gate.

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the