The gate valve can provide different discs or wedges. The range of the gate valve is usually determined by the type of wedge used.

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

Gate valves Gate valves are called rising valves or non-rising valves. Around the non-vertical stem gate valve, the stem is screwed into the gate around the lower end surface. Because the handwheel around the valve stem rotates, the gate will move the val

The stop valve is a linear motion valve, which can be used to start and stop and adjust the fluid flow. The stop valve is mainly used for throttling service and automatic control.

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

Globe valves are considered the industry standard for control valves because they are good at regulating flow, while ball valves are more suitable for on/off control without pressure drop.

Floating ball valves are widely used in various industries and attract more end users to replace gate valves and globe valves in cryogenic applications.

Forged steel gate valves are available in three bonnet designs. The first design is a bolted bonnet with male and female joints and spiral wound gaskets, made of F304/graphite. Ring joint gaskets are also available on request. The second design is a welde

This kind of gate valve is more flexible, because its gate can move up or down, there is no obstacle to the flow of fluid or gas, thus ensuring less friction.

Gate valves are the most common type of valve in any processing plant. It is a linear motion valve used to start or stop fluid flow. In use, these valves are either in the fully open position or in the fully closed position. When the gate valve is fully o

The ball valve is shaped like a bead. But the hole in the center is the same size as the pipe. It has gaskets on both sides of the flow, which can be completely closed. You can install it in any way. No matter which end you choose, one way to turn on the

Gate valves can be divided into two main types: parallel and wedge. The parallel gate valve uses a flat gate between two parallel valve seats. The popular type is a knife gate valve with sharp edges on the bottom of the gate.

You should store the valve on the floor in a clean, dry indoor area. Protect the valve from extreme temperatures and humidity, as well as exposure to excessive dust, humidity, vibration, deformation, sunlight and ozone.

The main difference between ball valves and globe valves is the way they close. A ball valve has a stem and a ball, which rotate horizontally and are usually called "rotary" valves. The globe valve has a stem and a plug, which stroke linearly, a

Wafer-type soft-seal butterfly valves use the flexibility of the rubber seat to easily achieve zero leakage, so they are widely used in oil fields, agriculture, water and wastewater, and mining industries. Because of its rubber-lined valve body material,