Its working principle is to lift or press a rectangular or circular gate connected by the valve stem to the fluid path by rotating the handle wheel clockwise and counterclockwise.

In a system with irregular changes in high temperature, the gate valve will leak due to the load in the valve end pipe.

The ball valve is designed to contain a ball in the valve. There is a hole in the middle of the sphere, and when the hole is aligned with the two ends of the valve, flow will occur. When the valve is closed by rotating the ball 90 degrees, the hole is per

The gate valve is not suitable for throttling volume. Due to the design of the valve, a partially opened gate of the fluid flow will cause serious damage to the valve, so flow control is difficult. Unless specifically authorized by the manufacturer, the g

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or

The valve seat of the gate valve is either provided integrally with the valve body or adopts a seat ring structure. The valve seat provided by the valve seat ring structure can be screwed into place or pressed into place and sealed and welded to the valve

The gate valve is designed for fully open or fully closed service. They are installed in the pipeline as isolation valves and should not be used as control or regulating valves.

The valve cage is a part of the valve, which surrounds the valve plug and is located in the valve body. The valve cage is the main component that determines the fluid flow in the valve. As the stopper moves, more cage openings are exposed and the flow rat

The valve body and bonnet are made of castings and are connected by flange joints. The seat surface of the valve seat and the wedges conform to the API 600 standard. The seat ring is welded into the valve body.

The gate valve allows the user to control the flow pressure instead of simply closing or opening it. Compared with ball valves, gate valves provide users with more control over water flow and pressure, but they cannot let users choose to stop the water fl

Forged steel gate valves are available in three bonnet designs. The first design is a bolted bonnet with male and female joints and spiral wound gaskets, made of F304/graphite. Ring joint gaskets are also available on request. The second design is a welde

Our company can also provide customized valve services according to your requirements. Feel free to contact us for more information or to request a complete product category.

The valve cover provides a leak-proof closure to the body. The threaded valve stem part will pass through a hole that has a thread similar to the valve cover, and the valve stem with the threaded part extends into the same hole as the valve cover thread.

You can expect the service life of the shut-off valve to be approximately 10 to 25 years, with an average of 20 years. However, if they are not "exercise" once a year or two years, then when you really need to close the valve for a pipeline emer

They are used as isolation valves in pipelines and should not be used as control or regulating valves. The operation of the gate valve is accomplished by turning the valve stem clockwise to close (CTC) or clockwise to open (CTO). When you turn the stem, t