The valve seat is responsible for the movement of the valve gate. It can also help to further seal the flowing medium. For gate valves, there are two valve seats according to the type of gate. Take the wedge valve as an example, the valve seats on both si

The assembly, start-up, and maintenance of gate valves require a lot of space.

Ball valves are often used for steam, water, oil, gas, air, and corrosive fluids. They can handle slurries and dusty dry fluids. The ball valve is not used for abrasive and fibrous materials, because it will damage the surface of the valve seat and valve

The plug or disc is an important part of the valve. It is connected to the valve stem and can be used for throttling.

The ball valve is designed to contain a ball in the valve. The ball valve is a form of quarter-turn valve that uses a hollow, perforated and rotating ball (called a "floating ball") to control the flow through it. It is open when the hole of the

The gate valve is a valve that completely restricts the flow of fluid and provides a full-diameter valve without changing the direction. The valve disc is appropriately called a gate here and is moved into the fluid at right angles by a threaded shaft wor

The structure of the wafer butterfly valve is formed by the central disc rotating 90 degrees in the valve body. Using the drive type, the flow of fluid can be stopped, adjusted or started. In the wafer connection, the valve is installed between pipe flang

For non-vertical stem type valves, if the valve is opened, the stem will not move upward. The stem is screwed into the dish. When the handwheel on the valve stem rotates, the disc moves up or down along the valve stem on the thread, while the valve stem r

As one of the leading gate valve manufacturers and suppliers in China, we warmly welcome you to buy cheap gate valve inventory from our factory here. All valves sold are of high quality and low price. If you need a price list, please contact us immediatel

The gate valve is designed for fully open or fully closed service. They are installed in the pipeline as isolation valves and should not be used as control or regulating valves.

We produce cast iron wafer butterfly valves, with hand lever or worm gear Operator. Our Butterfly Valves are widely used in drinking water system, sewage system, fire-fighting system. Butterfly Valves can produce from size DN40 to DN2400.

Ball valves and plug valves are very similar in basic functions and applications. Both are control valves used to provide tight shutoff in different types of piping units. They also work on the same basic principle, that is, using a porous disk to start o

Do not use the valve as a crowbar to open the flange, as this may cause damage to the flange area and/or damage to the O-ring seal.

In a system with irregular changes in high temperature, the gate valve will leak due to the load in the valve end pipe.

Because of its ability to cut off liquids, gate valves are often used in the petroleum industry. For extremely viscous fluids, special valves commonly called knife valves are used to cut off the liquid. A typical gate valve is designed to be fully open or